To ensure proper thread engagement and accurate torque readings, clean ALL threads in the block (ideally with a thread chaser or tap).
Clean and inspect all hardware prior to installation. Look for obvious defects or shipping damages, plus proper fit, length and dimension.
Screw studs into the block “HAND TIGHT ONLY”. NOTE: LOCTITE MAY BE USED IF A PERMANENT MOUNTING OF THE STUDS IS PREFERRED. THE FASTENERS, HOWEVER, MUST BE TORQUED PRIOR TO THE LOCTITE SETTING UP.
Install the main caps and check for binding or misalignment.
Lubricate the stud threads, nuts and washers with ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT. Then install the washers and the nuts onto the studs and tighten them hand tight.
ARP recommends using the ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT that is provided with each kit as opposed to engine oil. This is due to higher friction on the studs as well as inconsistencies in the clamping force of the fasteners when engine oil or other low quality lubricants are used.PRELOAD (TORQUE) RECOMMENDATIONS:
Following the manufacturers recommended torque sequence tighten the nuts in three equal steps to 90ft lbs with ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT.Ford Cosworth YB 16v Turbo
- Ford Sierra RS Cosworth 3 door 1986-1987
- Ford Sierra Cosworth RS500 1987
- Ford Sierra Sapphire RS Cosworth 2wd 1988-1989
- Ford Sierra Sapphire RS Cosworth 4wd 1990-1992
- Ford Escort RS Cosworth 4wd T34 1992-06/1994
- Ford Capri Mk1/Mk2/Mk3 1.6/2.0 1972-1987
- Ford Cortina Mk3/Mk4/Mk5 1.6/2.0 1970-1982
- Ford Escort Mk1 RS2000 2.0 1973-1974
- Ford Escort Mk2 RS2000 2.0 & Mexico 1.6 1975-1980
- Ford Granada Mk2 1.6/2.0 1977-1985
- Ford Granada/Scorpio Mk3 1.8/2.0 1985-1989
- Ford Sierra 1.6/1.8/2.0 1982-1989
- Ford Transit Mk2/Mk3 1.6/2.0 1978-1994
- TVR Tamsin 200 2.0
- Additional Information
Part No ARPMS02 Fits Engine Type Ford Cosworth YB, Ford SOHC (Pinto) Product Group Main Cap Bolts & Studs Stock Status Available From Stock Fits Engine Make Ford Catalogue 2017 Page Click HERE to view this part on page 44 of our 2017 catalogue Brand Logo Fits Model Variant Ford Escort Cosworth, Ford Sierra (2WD Cosworth), Ford Sierra (4WD Cosworth) Free Shipping
You may also be interested in the following product(s)
No Tax, Each £46.72 Taxed, Each £56.06
No Tax, Each £114.97 Taxed, Each £137.96
No Tax, Each £7.27 Taxed, Each £8.72
No Tax, Each £69.02 Taxed, Each £82.82
No Tax, Each £147.79 Taxed, Each £177.35
Crank spigot bearing (21x15mm): Ford X/Flow OHV Kent, SOHC Pinto, Lotus Twin Cam (6 bolt crank), BDA/BDG, Cosworth YB, Taunus/Cologne, Zetec E RWD, Duratec HE I4 RWD, DOHC 8v/16v RWD FP347No Tax, Each £4.84 Taxed, Each £5.81