This is a considerably more advanced mount than the standard Caterham part. It features a much greater usable rubber volume for absorbing vibration energy without increasing engine movement. It also has a more effective rebound (fail-safe) feature which limits upward movement as a result of extreme torque reaction or engine bounce. The base flange is 3mm thick as opposed to the original 2.4mm flange.
The greater load bearing rubber section gives considerably better vibration isolation over the OEM part as well as improved durability. In every way this is a superior engine mount.
Note: this mount is 3.5mm taller than the OEM part when installed. You should check clearances between the engine and bodywork before fitting.
The engine bracket must be at least 19mm diameter where it fits around the top bolt of the mount (see photo).
Price is for a single mount. Two are required for a car set.
Note, fits pre-metric chassis only (up to 2007) with a 4 cylinder engine fitted.
- Additional Information
You may also be interested in the following product(s)
No Tax, Each £51.96 Taxed, Each £62.35
No Tax, Each £400.00 Taxed, Each £480.00
Mintex M1155 rally/race rear brake pads: Ford Sierra/Sapphire/Escort Cosworth, XR4x4, Sierra ABS models & Granada Mk3 MDB1287M1155No Tax, Each £93.40 Taxed, Each £112.08
Helix HD clutch cover 190mm: Ford X/Flow OHV Kent Escort Mk2 (curly finger type) & 1.6 Pinto (not GT) 60-3329No Tax, Each £145.35 Taxed, Each £174.42
No Tax, Each £852.32 Taxed, Each £1,022.78
Mahle motorsport HD big end bearing set -0.010" Ford pre-X/Flow, X/Flow, BDA & Lotus Twin Cam VC1006/010No Tax, Each £84.90 Taxed, Each £101.88